Staging
v0.7.0
v0.7.0
https://github.com/torvalds/linux
Tip revision: 69e273c0b0a3c337a521d083374c918dc52c666f authored by Linus Torvalds on 01 September 2014, 01:23:04 UTC
Linux 3.17-rc3
Linux 3.17-rc3
Tip revision: 69e273c
exynos-adc.txt
Samsung Exynos Analog to Digital Converter bindings
The devicetree bindings are for the new ADC driver written for
Exynos4 and upward SoCs from Samsung.
New driver handles the following
1. Supports ADC IF found on EXYNOS4412/EXYNOS5250
and future SoCs from Samsung
2. Add ADC driver under iio/adc framework
3. Also adds the Documentation for device tree bindings
Required properties:
- compatible: Must be "samsung,exynos-adc-v1"
for exynos4412/5250 controllers.
Must be "samsung,exynos-adc-v2" for
future controllers.
Must be "samsung,exynos3250-adc" for
controllers compatible with ADC of Exynos3250.
- reg: Contains ADC register address range (base address and
length) and the address of the phy enable register.
- interrupts: Contains the interrupt information for the timer. The
format is being dependent on which interrupt controller
the Samsung device uses.
- #io-channel-cells = <1>; As ADC has multiple outputs
- clocks From common clock bindings: handles to clocks specified
in "clock-names" property, in the same order.
- clock-names From common clock bindings: list of clock input names
used by ADC block:
- "adc" : ADC bus clock
- "sclk" : ADC special clock (only for Exynos3250 and
compatible ADC block)
- vdd-supply VDD input supply.
Note: child nodes can be added for auto probing from device tree.
Example: adding device info in dtsi file
adc: adc@12D10000 {
compatible = "samsung,exynos-adc-v1";
reg = <0x12D10000 0x100>, <0x10040718 0x4>;
interrupts = <0 106 0>;
#io-channel-cells = <1>;
io-channel-ranges;
clocks = <&clock 303>;
clock-names = "adc";
vdd-supply = <&buck5_reg>;
};
Example: adding device info in dtsi file for Exynos3250 with additional sclk
adc: adc@126C0000 {
compatible = "samsung,exynos3250-adc", "samsung,exynos-adc-v2;
reg = <0x126C0000 0x100>, <0x10020718 0x4>;
interrupts = <0 137 0>;
#io-channel-cells = <1>;
io-channel-ranges;
clocks = <&cmu CLK_TSADC>, <&cmu CLK_SCLK_TSADC>;
clock-names = "adc", "sclk";
vdd-supply = <&buck5_reg>;
};
Example: Adding child nodes in dts file
adc@12D10000 {
/* NTC thermistor is a hwmon device */
ncp15wb473@0 {
compatible = "murata,ncp15wb473";
pullup-uv = <1800000>;
pullup-ohm = <47000>;
pulldown-ohm = <0>;
io-channels = <&adc 4>;
};
};
Note: Does not apply to ADC driver under arch/arm/plat-samsung/
Note: The child node can be added under the adc node or separately.